Creation of teaching material in the Mechanical Manufacturing Design Cycle (II)

Back

Teacher

Eugenio Alles Gómez

Centre

CIFP Miguel Altuna. Bergara

Date

07 February 2024

Description

It has been explained in the previous collaboration what this project for the Creation of Didactic Material consists of. With a piece of sheet metal with similar characteristics, in terms of level of difficulty and size, a specific layout is offered, that is, a chart of operations (subject to being varied), a series of necessary calculations and a possible bending design, depending on the layout, which would lead to the subsequent design of matrices, punches and finally the tooling (Die)

Comments

Calculations, graphic representation (AutoCad 2D). Result correction sheets:

1º) Make a design of a bent sheet metal part with dimensions and parameters with material characteristics.

2º) Argue mathematically and graphically the calculation of the development of the sheet metal.

3º) Perform a mathematical and graphical calculation of the elastic recovery

4º) Arrange cutting and bending punches based on their arrangement in the possible proposed operations chart. (There are always other possible arrangements)

5º) Send plans and graphic arguments.

The valuation is very positive. Knowledge transfer and collaboration (sending sketches, plans and suggestions) is done by email.

Estimated hours: 15